                                                                      
                                                                      
HP OMNIBOOK 2000/5700 NOTEBOOK PC - OS/2 WARP OR WARP CONNECT, INSTALLING
SCSI DRIVERS


INTRODUCTION
  
  When using the HP OmniBook Notebook PC with a docking system, use the
  following instructions to install SCSI support.  This procedure is not
  necessary if OS/2 was installed from a SCSI CD-ROM drive, because the
  SCSI drivers are already installed.
  

REQUIREMENTS
  
  *    HP OmniBook 2000/5700 Notebook PC with OS/2 Warp or Warp Connect 
       installed. 
  
  *    HP OmniBook 2000/5700 SCSI drivers.  To create a "SCSI Drivers"
       floppy disk, copy C:\OMNIBOOK\DRIVERS\OS2\SCSI\*.* to A:.  (To
       install correctly, the drivers must be in the root directory of
       the floppy disk.)  Or get the drivers from the HP OmniBook 
       2000/5700 Recovery CD in the \OMNIBOOK\DRIVERS\OS2\SCSI
       subdirectory. 

PROCEDURE
  
  1.   Insert the floppy disk with the SCSI drivers in drive A.
  
  2.   Open the OS/2 System folder, select the System Setup icon, and
       double-click Device Driver Install.
  
  3.   When prompted, type the path to the HP OmniBook Notebook PC
       SCSI drivers (such as A:\) and choose OK.
  
  4.   Select "AMD SCSI" and click OK.
  
  5.   Remove the floppy disk, then shut down OS/2 and reboot.

______________________________________________________________________
                  Copyright  Hewlett-Packard Co. 1997
       This information is subject to change without notice and
                 is provided "as is" with no warranty.
          Hewlett-Packard shall not be liable for any direct,
        indirect, special, incidental or consequential damages
             in connection with the use of this material.
