Tandy Professional Forum   Section: MS-DOS Applications
Subject: Tandy MMPC-10   Total messages: 1
==========================================

#62332   08/06/96   20:04:07
From: Thomas Aubin, 76461,3131
To:   All

I have a Tandy MMPC-10, a couple of months ago I replaced the
hard drive with a 1280 Meg western digital unit. Now I seem to
have a problem that I hadn't noticed before.
Before I replaced the drive, and ran the setup utility I had 4
comm ports. Now I only seem to have 3. I have tried to figure out
what is set wrong to no avail, I have Norton Utilities, and Check
It installed on this machiene as well as MSD from MS-DOS6.2
Norton Diagnostics, Checkit, and MSD all report something
different about my Com ports. They all list IRQ and Address
settings but no 2 programs aggree with each other. Also if I try
to check my IRQ status with any of the 3 the system locks up and
I have to re-boot to recover.
Anyone have any ideas where the problem may be or how to find
it?

Thanks.

Tom


