;Protocol.ini for the Western Digital EtherCard Plus and Plus/A
;Ethernet cards
;
;PROTOCOL.INI PARAMETERS
;
; This is a sample PROTOCOL.INI file for the MACWD Western Digital EtherCard
; NDIS MAC driver.  The [macwd] section shows examples of MACWD configuration
; parameter settings.  Comments at the end of the file explain these parameters
; and give their default, minimum and maximum values.  The [protocol manager]
; and [netbeui] sections aren't meant to be complete or realistic examples,
; except for the "bindings = macwd" line in the [netbeui] section.
;	The only parameter that must be specified is the "drivername".  Note
; that many of these parameters have default values (which are given below
; under "Comments about macwd parameters"). A parameter need not be specified
; in your PROTOCOL.INI if its default value is satisfactory.
;
;drivername
;     units:[n/a]
;     range:[macwd$]
;     default:[macwd$]
;
;     This parameter's value must be macwd$, it identifies the network
;     device driver.
;
;The following entries are optional under the [macwd] section.
;
;iobase (EtherCard Plus only)
;     units:[hex]
;     range:[200-3E0]
;     default:[280]
;
;     Indicates the base I/O address for the network adapter card.
;     This entry must match the adapter card's I/O address jumper settings.
;
;irq (EtherCard Plus only)
;     units:[n/a]
;     range:[2-15]
;     default:[3]
;
;Indicates the interrupt level of the network adapter card:
;
; Value         Meaning
; -----         -----------
; 2-7           EtherCard Plus: interrupt levels 2-7
;
; 3,4, 10, 15   EtherCard Plus/A (16-bit slot only): interrupt levels 3, 4,
;               10, and 15
;
;
;maxrequests
;     units:[integer]
;     range:[6-64]
;     default:[8]
;
;     Specifies the number of request queue entries.
;
;maxtransmits
;     units:[integer]
;     range:[6-64]
;     default:[12]
;
;     Specifies the number of transmit queue entries.
;
;ramaddress (EtherCard Plus only)
;     units:[hex]
;     range:[A000-EC00]
;     default:[D000]
;
;     Indicates the base address of the shared memory on the adapter
;     card.
;
;receivebuffers
;     units:[integer]
;     range:[6-96]
;     default:[12]
;
;     Specifies the number of receive buffer queue entries.
;     receivebufsize
;
;receivebufsize
;     units:[bytes]
;     range:[256-1536]
;     default:[256]
;
;     Specifies the size, in bytes, of a receive buffer.
;
;receivechains
;     units:[n/a]
;     range:[6-96]
;     default:[12]
;
;     Specifies the number of receive chain header queue entries.
;

