Reveal TV300 Version 6.54 Release Notes
==========================================
08 June 1994
================

Contents :
----------
A. System Settings Recommendations
B. Hardware/Software Configuration
C. Installation
D. Bugs Report


(A)System Settings Recommendations
----------------------------------
* An AT 486/33 computer
* Minimum 4 MByte System RAM
* Microsoft DOS v 5.0 or later


(B) Hardware/Software Configuration
-----------------------------------
This software release version is set up to use the following hardware
configuration:

	Video Port Address		0700H
	Video Memory Window Address/    Eh 
               Buffer Address
	Video Memory Window Size	32K
	Video Memory Initial State	Enabled, Random Access Mode
	Hardware Interrupt		IRQ 11H
	Tuner Port Address		02F0H

Your computer system should be set up to allow these hardware settings 
to be used.  If you used the upper memory area A000:0 to FFFF:F then 
you should make sure that there is no conflict with the 
video memory at that segment (from a network card, EMS card, or EMM386), 
and that there is no conflict with the hardware interrupt at IRQ 11H.


(C) Installation
----------------
1.	Insert the Reveal TV300 Installation Disk 1 of 2 in 
	floppy drive A: or B:.

2.	From the Windows Program Manager, select the File menu and choose 
	Run.  When prompted, enter the following command line:
		A:\SETUP        or         B:\SETUP

3.	The Setup program will prompt you for a directory where it will 
	install its Windows applications.  The default is C:\TV300.

4.	The Setup program will copy the video drivers and applications to 
	the hard disk.  When this is done, it will create a program group 
	for its applications, and will update SYSTEM.INI and WIN.INI.

5.	The installation will prompt you for disk 2. Insert the 
	Reveal TV300 Installation Disk 2 of 2 in floppy drive A: or B:.

7.	The Setup program will copy the neccessary Video For Windows Runtime
        Libraries into the hard disk.


With 16MB RAM & above
=====================

1.  If you have more than 16MB on your motherboard.  Please choose a value
( buffer address ) in the page addressing mode: A000:0 to F800:0.  To change
this, run the Address Setup Program.

2.  To help you decide which buffer address in the range to choose, while you 
are in Windows, go to the program manager's file menu, select Run....  Type MSD 
in the Command Line.  MSD is a Microsoft system Diagnostics Program and you can 
used this to help you select an unused memory location.

3.  If EMM386 is loaded, please disable the EMM386 in the config.sys. If you 
need to have EMM386 loaded in your system for some reason, you could exclude 
the address area which you like to use as the buffer address for TV300.

For example, to use buffer address D000, you could type the following in the 
Config.sys file:

	device=EMM386.exe noems X=D000-D7FF

4.  Please make sure that your system SHADOW RAM setup is not enabled for the
selected buffer address. 


(D) Bugs Report
---------------
Please direct all bugs found in this software release to:
        
        Kathy Woon
        Cogent Electronics Inc.
        USA
        Fax: (415) 591-8310

and indicate the version of the Reveal TV300 you received. Thank you.


Note : ** indicates importance.

